Jigs

There are 2 of each jig sets: named A + B

All are labeleld with T to indicate the Top of each jig

• Jig Heights - Set up for Jig A

28th February

• First tests using Salad cream
  • Too much used
  • Glass slide not aligned to vacuum jig
  • However, x-y rotation (or lack of) looks v good

29th Feb

Picked up bad asics

Wed 7th

Used glue with glass slides

20 Glass ASICS : 0.86g

20 ASICS: 0.83g

Glass slide : 1.96g

Glass ASICS + Slide = 2.82g

After Gluing. 3.05g

Glue used = 0.23g

Notes:

• Uneven spreading using a q tip. Have now purchased glue spreaders to help even out distribution
• jig looks uneven at bottom left corner. 5 spots blurring into 1
• left vacum off
• 3pm - 10am for curing

Mon 12th

Notes

• Used glue spreader
• imotved definistion of 5 dots
• However, slides stuck to stencil insterad of vacuum

Tues

• Used original stencil
• same results (sticking)
• is the glue spreader forcing glue uinder the stencil?

Testing

Hybrid Specific HSIO Configuration and test results

For testing hybrids it is important to use the NoBCCSetup script with the following settings:

e->ConfigureVariable(10016, 0x7883); e->Sleep(10);
e->ConfigureVariable(10023, 0x00A0); e->Sleep(10);

It is necessary to set the L1Delay in the module config file to 129 (was originally set to 132 for BCC), also the st_system_config has to be modified to use the J37 IDC on HSIO, setting s0/s1 to 2 0 respectively and the d0/d1 delays to 20.

https://twiki.cern.ch/twiki/bin/viewauth/Atlas/ShortStripsHybridLiverpool

Inventory