Line: 1 to 1 | ||||||||
---|---|---|---|---|---|---|---|---|
Multi Module Set-up | ||||||||
Line: 10 to 10 | ||||||||
Pages on running the RCE can be found here. | ||||||||
Changed: | ||||||||
< < | The system is based up the RCE firmware to control and monitor each module (single or quad chip sensor). | |||||||
> > | The system is based up the RCE firmware to control and monitor each module (single or quad chip sensor). At them moment we have 4 RCEs, which gives the potential to run 32 (8x4) chips. | |||||||
Changed: | ||||||||
< < | Single module set-up | |||||||
> > | Basic set-up | |||||||
Changed: | ||||||||
< < | The single module set-up at Glasgow uses an RCE board with an external switch (Baseline 2948) and is attached to an HSIO board and Cosmic board with 8 RJ45 ports. | |||||||
> > |
| |||||||
Changed: | ||||||||
< < | Multi module set-up | |||||||
> > | Power Supplies | |||||||
Changed: | ||||||||
< < | For 16 chips, i.e. 4 quad modules, two RCE cards are required. Each RCE board has two separate cards and along with 2 HSIO boards (i.e. one more) this is compatible with 16 chips. However, the Cosmic must be replaced with two IBL type adapter boards, each with 8 inputs and 16 outputs on a 100 pin Samtec connector. | |||||||
> > | LVDS
| |||||||
-- ![]() |